2m Cat.6e UTP Cable, 24AWG, CCA, 4-Pair, OD=6.3mm, Grey - 2L-4102-GR

The provided data confirms it is a 4-pair Cat.6e UTP cable with 24AWG CCA conductors. It can be used where a Cat.6e UTP cable with matching connectors is required. The connector/interface type (for example, RJ45/8P8C plugs or bare wire) is not specified in the available information, so compatibility with a specific router, switch, patch panel, or keystone jack should be confirmed with Bizgram or the manufacturer before purchase.

It is 2 meters long, with an outer diameter (OD) of 6.3mm. It uses 24AWG conductors, 4 twisted pairs, and is grey. It is a UTP (unshielded twisted pair) cable. Other dimensions, such as connector dimensions or bend radius, are not provided and should be confirmed with Bizgram or manufacturer documentation.

Installation and setup details are not fully specified. If it is a pre-terminated patch cable, it would typically be connected between compatible ports; if it is bulk cable, it would require terminating with compatible connectors. Because the termination type is not confirmed, verify installation requirements with Bizgram or the manufacturer. No tools, mounting hardware, or instructions are included in the provided information.

The provided query does not list a warranty duration, support terms, or manufacturer brand. These should be confirmed with Bizgram or the manufacturer documentation before purchase.

The condition (new, refurbished, used, etc.) is not specified in the provided information. Confirm the condition with Bizgram or the manufacturer/seller before ordering.

This is a passive copper cable and does not itself provide power. It may be used in power-over-Ethernet (PoE) setups only if the cable construction and connectors support the required current and voltage. The provided data does not specify PoE rating, conductor material performance, or safety certifications; CCA conductors can have different electrical characteristics than solid copper. Confirm PoE suitability with Bizgram or the manufacturer.

The cable is marketed as Cat.6e, 4-pair, 24AWG, CCA, with 6.3mm OD. Cat.6e is not a formally recognized TIA/ISO category in the same way as Cat.6 or Cat.6A, so certified performance, bandwidth, and maximum data rate are not verifiable from the provided information. Actual performance depends on installation, length, connectors, and connected equipment. Confirm supported standards and ratings with Bizgram or manufacturer documentation.

No. A passive cable does not require an operating system, firmware, drivers, or software licenses. If the cable is used with active networking equipment, that equipment's own OS, firmware, and licensing requirements apply separately.

The provided information does not list box contents or included accessories. Confirm what is included (for example, cable only, connectors, clips, documentation) with Bizgram or the manufacturer before purchase.

Environmental ratings such as indoor/outdoor use, temperature range, UV resistance, and fire/safety rating are not provided. Because CCA conductors and UTP construction may be intended for specific environments, confirm deployment suitability (home, office, plenum/riser, outdoor, etc.) with Bizgram or the manufacturer.